Troubleshooting - SilverCrest SMW 900 EDS B3 Mode D'emploi

Clean the turntable 3 regularly. Clean the
•
plate in warm soapy water.
Clean the grill stand t in warm dishwater and
•
dry it well.
• Regularly eliminate odours. Place a deep micro-
wave bowl with a cup of water and the juice
and peel of a lemon into the microwave oven.
Heat it up for 5 minutes. Wipe off thoroughly
and rub dry with a cloth.
• Should replacement of the bulb in the micro-
wave be necessary, arrange for it to be ex-
changed by a dealer or consult our Service
Department.

Troubleshooting

The display 1 indicates nothing.
• The plug is not inserted into a power socket.
Check the plug.
• The mains power socket is defective.
Try another mains power socket.
The display 1 is defective. Contact our
•
Customer Services Department.
The appliance does not respond to pressing
the buttons.
• The Child safety facility is activated. Deactivate
the Child safety facility (see chapter "Operation").
The appliance does not start the cooking/
warming process.
• The door is not properly closed. Close the
door correctly.
The turntable 3 generates loud noise when
revolving.
The turntable 3 is not correctly positioned on
•
the axle. Insert the turntable 3 correctly into
the cooking area.
The small rollers 4 and/or the floor of the
•
cooking area are unclean. Clean the rollers 4
and the floor of the cooking area.
The display 1 indicates "E01" and signal tones
sound.
• The microwave is overheated. Terminate the
current programme immediately. Remove the
plug from the mains power socket, open the
microwave door and allow the appliance to
cool down.
The display 1 indicates "E02" and signal tones
sound.
• There is an error on the sensor. Interrupt the
programme and let the appliance cool down.
Then restart the microwave. If the error occurs
again, contact Customer Support.
• There is an error during the heating up of the
appliance. Interrupt the programme and let the
appliance cool down. Then restart the micro-
wave. If the error occurs again, contact Customer
Support.
The display 1 indicates "E03" and signal tones
sound.
• Due to a short circuit or open circuit voltage,
the microwave has switched into fault protec-
tion. Stop the programme and remove the
power plug. If possible, eliminate the problem,
e.g. metals in the cooking area, which can
lead to the above problem when using the
microwave function. Otherwise, please contact
our Customer Support.
- 27 -