Troubleshooting - Electrolux EHI8742FOK Notice D'utilisation

12 www.electrolux.com
the scraper on the glass surface at
an acute angle and move the blade
on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metallic
discolorations. Use a special clean-

6. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
An acoustic signal sounds
and the appliance deacti-
vates.
An acoustic signal sounds
when the appliance is de-
activated.
The appliance deactivates. You put something on the
The residual heat indicator
does not come on.
The Automatic Heat Up
function does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
Problem
2.
3.
Possible
You touched 2 or more
sensor fields at the same
time.
The Stop+Go function op-
erates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
sensor field .
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting is
set.
The Power management
is activated.
The cookware is too large
or you put it too near to
the controls.
ing agent for glass ceramic or stain-
less steel.
Clean the appliance with a moist cloth
and some detergent.
At the end rub the appliance dry
with a clean cloth.
Remedy
Activate the appliance
again and set the heat set-
ting in less than 10 sec-
onds.
Touch only one sensor
field.
Refer to the chapter "Daily
use".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the cooking zone oper-
ated sufficiently long to be
hot, speak to the service
centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Refer to "Power manage-
ment".
Put large cookware on the
rear cooking zones if nec-
essary.