Care And Cleaning; General Information; Troubleshooting - Electrolux EHO8840FOG Notice D'utilisation

6. CARE AND CLEANING

WARNING!
Refer to Safety chapters.

6.1 General information

• Clean the hob after each use.
• Always use cookware with clean
bottom.
• Scratches or dark stains on the surface
have no effect on how the hob
operates.
• Use a special scraper for the glass.
• Use a special cleaner applicable for the
surface of the hob.
6.2 Cleaning of the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate or op-
erate the hob.
All manuals and user guides at all-guides.com
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is released.
You touched 2 or more
sensor fields at the same
time.
STOP+GO function oper-
ates.
the dirt can cause damage to the hob.
Put the special scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and some detergent. After
cleaning, rub the hob dry with a soft
cloth.
• The surface of the hob has horizontal
grooves. Clean the hob with a moist
cloth and some detergent with smooth
movement from left to right. After
cleaning, rub the hob dry with a soft
cloth from left to right.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the con-
nection diagram.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to "Daily use" chapter.
ENGLISH 13