Electrolux EHO8840FOG Notice D'utilisation page 14

14 www.electrolux.com
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva-
ted.
The hob deactivates.
Residual heat indicator
does not change colours.
Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
The backlight is on, but the
contrast of the display is
bad.
There is no signal when you
touch the panel sensor
fields.
II and text come on.
comes on.
? comes on.
All manuals and user guides at all-guides.com
Possible cause
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field
The zone is not hot be-
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
Power management func-
tion is activated.
The cookware is too large
or you put it too near to the
controls.
The hot cookware is on the
display.
The signals are deactivated. Activate the signals.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
Remedy
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
.
If the zone operated suffi-
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the
function.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.
Remove the object and let
the hob become sufficiently
cool. If the contrast is not
clear, speak to an Author-
ised Service Centre.
Refer to "Daily use" chapter.
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.