Electrolux EHI8742FOK Notice D'utilisation page 13

Problem
There is no signal when
you touch the panel sen-
sor fields.
comes on.
comes on.
comes on.
and a number come
on.
comes on.
comes on.
Possible
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device or
the Lock function oper-
ates.
No cookware is on the
cooking zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware do not cov-
er the cross.
There is an error in the ap-
pliance.
The electrical connection
is incorrect. The supply
voltage is out of range.
There is an error in the ap-
pliance because a cook-
ware boils dry. The over-
heating protection for the
cooking zones and the
Automatic Switch Off op-
erate.
ENGLISH
Remedy
Activate the signals (refer
to "OffSound control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Daily
use".
Put cookware on the
cooking zone.
Use cookware with cor-
rect dimensions.
Cover the cross fully.
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If comes
on again, speak to the
service centre.
Speak to a qualified elec-
trician to check the instal-
lation.
Deactivate the appliance.
Remove the hot cook-
ware. After approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
"Cookware for the induc-
tion cooking zone" to see
if your cookware is com-
patible with the appliance.
13