Installation; Connection Cable - Electrolux EHI8742FOK Notice D'utilisation

14 www.electrolux.com
comes on.
comes on.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.

7. INSTALLATION

WARNING!
Refer to "Safety information" chap-
ter.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
7.1 Built-in appliances
• Only use the built-in appliances after you
assemble the appliance into correct
Problem Possible
The cooling fan is blocked. Check if objects block the
The electrical connection
is incorrect. The appliance
is connected only to one
phase.
Make sure, you operated the appliance
correctly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer serv-
ice and conditions of guarantee are in the
guarantee booklet.
built-in units and work surfaces that align
to the standards.

7.2 Connection cable

• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with
a special cable (type H05BB-F Tmax
90°C; or higher). Speak to your local
Service Centre.
Remedy
cooling fan. If comes
on again, speak to the
service center.
Connect the appliance as
you see it in the connec-
tion illustration.