Quick Start - Multiple System Setup - Samson CONCERT 88 Manuel De L'utilisateur

Quick Start - Multiple System Setup

When using multiple systems, each system must be set to a different operating channel.
Transmitter and receiver pairs must be on the same channel plan in order to work
together (See "Concert 88 Channel Plans" on page 20).
8. Press button on transmitter to turn on
When setting an additional transmitter, make sure to close all other transmitter bat-
tery compartments to ensure that the IR Lens is covered.
To change the operating channel of a system, press
the SELECT button on the front of the CR88 receiver.
The channel number will increase by one digit, from
0-9 then A-F. Once the last channel has been reached,
the count will cycle back to 0.
Turn on the power to the transmitter by pressing and holding the Power switch; the
indicator LED will light green.
5. Plug receiver into audio system
8. Press button on transmitter to turn on
Concert 88 Wireless System
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
FREQ:
(2) this device must accept any
542-566MHz
interference received, including
interference that may cause
undesired operation.
8. Turn on belt pack transmitter
6. Press Select button to change channel
9. Press and hold SELECT button to IR
9. Press and h
17