Maintenance And Cleaning - Vortice Depuro Sky Notice D'emploi Et D'entretien

ENGLISH

Maintenance and cleaning

Filters - general informations
The maintenance for the correct functioning of the device essentially consists of replacing the filters.
These are the most important component for the effectiveness of air purification.
All maintenance, repair or overhaul operations of the device must be carried out by professionally qualified
personnel. All necessary safety measures must be taken to avoid any risk to the user.
CAUTION: in order to safely carry out any internal maintenance work on the device, the use of suitable
PPE (Individual Protection Devices) (at least mask and gloves) is mandatory. The device has two
stickers (one on each removable filter cover), which warn of the need to use protective elements before
handling the unit. Once the filter protection has been removed, it must be repositioned in the filter housing.
CAUTION: Failure to use PPE exposes you to risks related to possible contact/aspiration of pathogens
previously collected in filters.
The device is supplied with the relevant certificates for HEPA H14 filters.
CAUTION: do not use similar or theoretically equivalent filters without prior consultation and authorisation from
the manufacturer. In case of use of unauthorised filters for replacement, the original filtration capacity of the
appliance is not guaranteed.
Filter service life
The following details the service life of the two types of filters that equip the device, both for "clean"
environments (e.g. offices, hospitals, etc.) and "dirty" environments (e.g. warehouses, industrial buildings, etc.):
ISO COARSE 65% (G4) pre-filter and ISO ePM1 70% (F7) filter → "clean" environments: 4 / 6 months (4,000
h); "dirty" environments: 2 / 4 months (2,000 h)
high efficiency HEPA H14 absolute filter (provided it is equipped with ISO COARSE 65% pre-filter) → clean
environment: 10 / 12 months (8,000 h)/ "dirty" environments: 8 / 10 months (4,000 h).
CAUTION: the service life of the filters can be reduced by several factors such as: quality of the air to be
purified, air flow, correct maintenance of the pre-filter. It is advisable to carry out periodic preventive checks of
the filters, regardless of what is indicated by the alarms issued by the Regulator (provided that a Reg Depuro
is used).
Filters - Replacement
The need for periodic filter replacement is indicated on the control panel supplied with the device.
The device must be disconnected from the power supply before performing any maintenance work.
Depuro Sky
The device is equipped with 15 filters, positioned on the
bottom and sides of the part of the device housed in the
room (Fig.xx-yy). The filter types on the device are shown
below and in figure:
5 ISO Coarse 65% (G4) pre-filters
5 ISO ePM1 70% (F7) filters
5 HEPA 99.9% (H-14) filters
Depuro Sky Easy
The device is equipped with 6 filters, positioned on the
bottom and sides of the device.
The filter types on the device are shown below and in
figure:
1 ISO Coarse (G4) 65% pre-filter
1 ISO ePM1 (F7) 70% filter
4 HEPA H-14 (99.9%) filters
10
Filter
Filtro
ISO ePM1
(F7)
11
Filter
Filtro
HEPA
(H14)
Filter
Filtro
ISO Coarse
(G4)
Filter
Filtro
HEPA
(H14)
Filter
Filtro
ISO Coarse
(G4)
Filter
Filtro
ISO ePM1
(F7)
21