Description And Operation; Safety - Vortice ARIETT HABITAT 15/30 LL Notice D'emploi Et D'entretien

ENGLISH

Description and operation

The product you have purchased is a professional
room ventilating unit for wall or ceiling installation, with
discharge into a single ducting system. The appliance
operates at two speeds (minimum and maximum). All
the models have an IPX4-grade, spray protection, and
are thus ideal for installing in high-humidity
environments. The appliance has a constant minimum
speed mode. The maximum speed setting can be
manually activated (fig.B).
The appliance has a ball bearings motor that
guarantees at least 30,000 hours of silent, trouble-free
mechanical operation.

Safety

Warning:
!
this symbol indicates that care must
• Do not use this appliance for functions other than
those described in this booklet
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician or
Vortice. Do not leave packaging within the reach of
children or infirm persons
• Certain fundamental rules must be observed when
using any electrical appliance, including:
- never touch electrical appliances with wet or damp
hands;
- never touch appliances while barefoot;
- never allow children or infirm persons to operate
appliances unattended.
• Store the appliance out of the reach of children and
differently able persons after deciding to disconnect
it from the power supply and use it no more.
• Do not us the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
This appliance can be used by
•
children aged from 8 years and
above and
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have
supervision
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not
appliance. Cleaning and user
maintenance shall not be made
by children without supervision.
These appliances are designed
•
6
persons with
been given
or instruction
play with
for use
commercial properties.
The appliance must be installed
•
by a professionally qualified
electrician.
The electrical system to which
•
the product is connected must
be in
applicable regulations.
• Always use the backdraught shutter supplied with
the appliance if installing it to drain directly to the
outside with no duct (fig. 15).
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Do not place objects on top of the appliance.
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not use
it and contact Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately and
ensure that only genuine original Vortice spares are
used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice
• The mains power supply to which the units are
connected must comply with current laws.
• The appliance is double insulated and therefore
does not need to be earthed
• The electrical power supply/socket to which the
appliance is to be connected must be able to provide
the maximum electrical power required by the
appliance
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function correctly;
b) before cleaning the outside of the appliance, c) if
the appliance is not to be used for any length of time.
• Ensure that the room has an adequate source of
fresh air to ensure correct appliance operation. In
the event that other non-sealed combustion-based
appliances (such as water heater or gas stove) are
installed in the same room, check that air
replacement is sufficient for all appliances to work
effectively together.
• The appliance cannot be used to control activation
of water heaters, room heaters, etc. and it must not
exhaust into the hot air flues.
• Ensure that the appliance discharges into a single
duct (dedicated to this product) or directly to the
the
outside.
• The air to be extracted from the room must be clean
(i.e. free of grease, soot, chemical and corrosive
agents, and explosive or flammable mixtures).
• Do not cover or block appliance intake or outlet vents
grilles as this may prevent optimum air flow.
An omnipolar switch with a
•
in residential
compliance
and
with