JUKI LK-1941 Manuel D'utilisation page 29

(18) Tilting the sewing machine head
WARNING :
When tilting/raising the sewing machine head, perform the work so as not to allow your fingers to
be caught in the machine. In addition, to avoid possible accidents caused by abrupt start of the
machine, turn OFF the power to the machine before starting the work.
5
1
When tilting the sewing machine head, tilt the head
gently until head support rod 1 comes in contact
with the head.
2
3
4
1. Make sure that head support rod
1 is attached to the machine table
before tilting the sewing machine
head.
2. When the sewing machine head
is tilted, feeding frame 2 moves
to the left side by itself and
interferes with the intermediate
presser or the like. As a result, it
will be the cause of breakage.
Remove the aforementioned
component in advance, or fix feed
plate 3 to throat plate support
cover 4 with tape or the like, and
tilt the sewing machine head.
3. When tilting the sewing machine
head while holding motor cover
5 and throat plate support cover
4 , the covers may be bent. Be
sure to tilt the sewing machine
head while holding the main unit
of the sewing machine.
4. Be sure to tilt the sewing machine
head on a flat place to prevent it
from falling.
17