Threading The Machine Head - JUKI LK-1941 Manuel D'utilisation

3. Threading the machine head

WARNING :
Do not place your fingers or any thing under the presser since there is a danger of damage of your
fingers or hands caused by being caught in the presser, needle, etc.
G type, Z type
H type
20
When threading through the needle, perform following
operation to lower the intermediate presser and the
feeding frame.
1) Press key on the operation box to light up
the threading LED.
2) Press key and the intermediate presser and
the feeding frame come down.
3) After threading through the needle, press again
key, and the intermediate presser and the feeding
frame return to their home positions.
Pull out the thread by approximately 4 cm from the
needle after threading through the needle.
Normal
When the needle thread remaining on the needle
after thread trimming is short due to the
resistance of thread path. (when using coating
thread, net for thread on thread stand, etc.)
To make one turn