DeWalt DCN891 Guide D'utilisation page 14

English
Pin bends.
Cause:
-
-
-
Action:
-
-
-
STEEL
Pin does not penetrate the surface.
Cause:
-
-
Action:
-
Pin breaks or bends.
Cause:
-
-
-
Action:
-
-
Pin does not hold in the steel.
Cause:
-
Action:
-
Headlights/LED Indicator (Fig. A)
There are low battery and jam/stall indicator lights
located on the front of the tool on each side of
the magazine.
12
Pin hit large aggregate
on entry.
Too hard/high
strength concrete.
Pin hit rebar just
under surface.
Use shorter pin.
Make sure nailer is
perpendicular to the
work surface.
Move 3" (8 cm) and
try again.
Power setting too low.
Material to hard for
pin type.
Increase tool power setting.
Pin too long.
Power setting too low.
Material to hard for
pin type.
Use shorter pin.
Switch to higher
power setting.
Steel base material too thin.
Use thicker base material.
9
LOW BATTERY
Replace battery with a charged pack.
HOT PACK
Let the battery cool or replace it with
a cool pack.
JAM/STALL CONDITION
Rotate the stall release lever
to release.
Refer to Stall Release or Clearing a
Jammed Pin.
HOT TOOL (Both LEDs Flashing)
Let the tool cool down before
continuing use.
ERROR
Reset tool by removing and
reinserting battery pack or cycling
trigger lock off. If error code persist,
or any other
take tool to an authorized D
combination.
service center.
Stall Release (Fig. J)
If the nailer is used in harder material where all available
energy in the motor is used to drive a fastener, the tool may
stall. The driver will not complete the drive cycle and the
jam/stall indicator will flash. Rotate the stall release lever
on the tool and the mechanism will release.
nOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted. If the
driver does not automatically return to the home position,
proceed to Clearing a Jammed Pin. If the unit continues
to stall please review the material and fastener length to
be sure that it is not too rigorous an application. The nailer
could also be overheated and needs time to cool before
further use.
Fig. J
Clearing a Jammed Pin (Fig. A, K)

WARNING: To reduce the risk of serious personal
injury, disconnect battery pack from tool before
making any adjustments, changing accessories,
servicing, or moving the tool. Such preventative
safety measures reduce the risk of starting the
tool accidentally.

CAUTION: When removing a jammed pin, DO
NOT orient the nailer with the nose up or with
WALT
e
8
8