Bartscher 200 LN Mode D'emploi page 34

Changing the door's direction (fig. 4, 5)
•
If necessary, the direction in which the door opens can be changed. A size 8 and
size 10 wrench is necessary, as well as a Philips screwdriver.
CAUTION!
When adjusting the door's opening direction, do not set the deep freezer
vertically!
•
Warning! Prior to changing the direction of the door, disconnect the device from its
power source by removing the plug from its socket.
•
Perform the following steps in the order they are given:
1. Open the device's door.
2. Remove the four covers (c) located on the housing and at the inside of the door.
3. Rotate the cover flap by180° and place it at the other side.
4. Unscrew the pin on the inside of the door in area (c)/(6). Attention! Hold on to
the door of the device.
- 32 -
Fig. 4, 5