Bartscher 200 LN Mode D'emploi page 33

•
Do not place the deep freezer in areas with high humidity, as this may damage
the device and reduce its cooling output.
•
Do not cover or clog the ventilation openings at the top of the device.
Ensure free air circulation.
Fig. 2
•
Place the device on a flat, level surface; it may not lean against a wall.
•
In order for the door to close automatically, adjust the device's legs to make it tilt back
slightly. To do this, gently lift the device at its front until the legs are above the floor.
Connecting the device
DANGER! Electrical hazard!
Improper connection of the device to a power source may lead to injury from
electric shock!
Before installing, compare the local network's parameters with the rating plate on
the device.
Only connect the device to a power source when it is compliant with all
parameters. Follow all safety rules!
•
Attention! If the device is tilted further than 30° , wait a minimum of 4 hours before
connecting it to a power source. Failure to wait may lead to damage to the compressor.
•
The socket and circuit must be secured to a minimum of 16A. Only connect the
device to a wall socket, do not use power strips or splitters.
•
Locate the device so that the plug is easily accessible in case it is necessary to
quickly disconnect the device from its power source.
•
Maintain a minimum of 10 cm between
the top of the device and objects located
above it (e.g. cupboards). Failure to do
so may result in increased energy use or
overheating of the compressor (fig. 2).
•
If the device is located in the corner of a
room, maintain a minimum of 6 cm at
the sides in order to open the door wide
enough to enable access to drawers
(fig. 3).
Fig. 3
- 31 -