Last Calor SUSANNA Manuel D'installation, D'utilisation Et D'entretien page 41

Signalling
Occurs in case of intervention
of the auger duct temperature
safety thermostat.
AL 8
SIC DEP In the work phase the stove
detects a pressure lower than
the vacuum switch threshold
setting .
Occurs when the stove has
SERVICE
exceeded the hours of
DUE operation or 2000 Kg pellet
since the previous service
The Manufacturer reserves the right to make technical or aesthetic changes to the products at any time without notice.
The drawings, measurements, diagrams and any other configurations are given only by way of example.
COLA S.r.l.
– Viale del Lavoro, 7/9 – 37040 Arcole (VR) Italy – Tel. 045 6144043 – Fax 045 6144048 – Amministrazione: amministrazione.cola@ferroli.com
C.F. / P.IVA e Iscr. Reg. Impr. 02990180230 – ID-SDI: AU7YEU4 – Pec: cola@legalmail.it – Capitale Sociale Euro 52.000,00 i.v.
R.E.A. VR-301021 – Socio Unico – e-mail: info@anselmocola.com – website: www.colastufe.com
ALARMS - MESSAGES
Fault
-The safety thermostat has
detected a temperature above
the setting threshold due to
overheating of the bottom part
of the hopper, blocking
gearmotor operation.
- Overheating due to use of
the stove for too long
- Brazier clogged with
excessive accumulated ash.
- The combustion chamber is
dirty
- The fume duct is blocked
- The fire door is not closed
- The overpressure valves are
open-jammed
- The vacuum switch is faulty.
The stove requires
extraordinary maintenance
Direzione e coordinamento della Ferroli S.p.A.
Possible causes
41
Cures
- Check the cleanness of the
fume duct and the combustion
chamber, hermetic closure of
the door and the overpressure
valve. Then repeat the lighting
procedure
Reset the safety thermostat by
pressing the reset button and
repeat the lighting procedure.
- Other reinstatement
operations must be carried out
by a service centre
The stove continues its normal
operation. It is advisable to
contact a service centre
as soon as possible
SUSANNA