Optimizing Sound By Time Alignment - Listening Position; Adjusting The Listening Position - Sony WX-GT90BT Mode D'emploi

Optimizing sound by Time
Alignment — Listening
Position
The unit can simulate a natural sound field
by delaying the sound output from each
speaker to suit your position.
The options for "POSITION" are indicated
below.
FRONT L (): Front left
FRONT R (): Front right
FRONT (): Center front
ALL (): In the center of
your car
OFF: No position set
You can also set the approximate subwoofer
position from your listening position if the
listening position is set to other than "OFF."
The options for "SET SW POS" are
indicated below.
NEAR (): Near
NORMAL (): Normal
FAR (): Far
1
During reception/playback, press
, rotate the control dial until
"SOUND" appears, then press it.
2
Rotate the control dial until
"POSITION" appears, then press it.
3
Rotate the control dial until "SET F/R
POS" appears, then press it.
4
Rotate the control dial to select from
"FRONT L," "FRONT R," "FRONT,"
or "ALL," then press it.
5
Rotate the control dial until "SET SW
POS" appears, then press it.
6
Rotate the control dial to select the
subwoofer position from "NEAR,"
"NORMAL," or "FAR," then press it.
32
7
Press (BACK) to return to the
previous display.
To cancel listening position, select "OFF" in
step 4.
Adjusting the listening
position
You can fine-tune the listening position
setting.
1
During reception/playback, press
, rotate the control dial until
"SOUND" appears, then press it.
2
Rotate the control dial until
"POSITION" appears, then press it.
3
Rotate the control dial until "ADJ
POSITION" appears, then press it.
4
Rotate the control dial to adjust the
listening position, then press it.
Adjustable range: "+3" – "CENTER" –
"–3."
5
Press (BACK) to return to the
previous display.
DM+ Advanced
DM+ Advanced improves digitally
compressed sound by restoring high
frequencies lost in the compression process.
During playback, press , rotate
1
the control dial until "SOUND"
appears, then press it.
2
Rotate the control dial until "DM+"
appears, then press it.
3
Rotate the control dial to select "ON,"
then press it.
4
Press (BACK) to return to the
previous display.