Optimizing Sound By Time Alignment - Listening Position; Adjusting The Listening Position - Sony CDX-GT450U Mode D'emploi

5
Setting the equalizer curve.
1 Rotate the control dial to select the
frequency range, then press it.
BAND1: 63 Hz
BAND2: 160 Hz
BAND3: 400 Hz
BAND4: 1 kHz
BAND5: 2.5 kHz
BAND6: 6.3 kHz
BAND7: 16.0 kHz
2 Rotate the control dial to adjust the
volume level, then press it.
The volume level is adjustable in 1 dB
steps, from -6 dB to +6 dB.
Repeat steps 1 and 2 to adjust other
frequency ranges.
6
Press (BACK) twice.
The equalizer curve is stored in "CUSTOM,"
and the display returns to normal reception/
play mode.
Optimizing sound by Time
Alignment — Listening Position
The unit can change the localization of sound by
delaying the sound output from each speaker to
suit your position, and simulate a natural sound
field with the feeling of being in the center of it
wherever you sit in the car.
The options for "POSITION" are indicated
below.
"FRONT L" (1): Front left
"FRONT R" (2): Front
right
"FRONT" (3): Center front
"ALL" (4): In the center of
your car
"OFF": No position set
You can also set the approximate subwoofer
position from your listening position if:
– the audio output is set to "SUB-OUT"
(page 17).
– the listening position is set besides "OFF."
16
The options for "SET SW POS" are indicated
below.
"NEAR" (A): Near
"NORMAL" (B): Normal
"FAR" (C): Far
1
During reception/playback, press the
select button.
2
Rotate the control dial until "SET
POSITION" appears, then press it.
3
Rotate the control dial to select from
"FRONT L," "FRONT R," "FRONT" or
"ALL," then press it.
4
Rotate the control dial until "SET SW
POS" appears, then press it.
If you select "FRONT L," "FRONT R,"
"FRONT" or "ALL" in step 3 above, you can
set the subwoofer position.
Rotate the control dial to select from
"NEAR," "NORMAL" or "FAR," then press
it.
5
Press (BACK).
The display returns to normal reception/play
mode.
To cancel listening position, select "OFF" on
step 3.

Adjusting the listening position

You can fine-tune the listening position setting.
1
During reception/playback, press the
select button.
2
Rotate the control dial until "ADJ
POSITION" appears, then press it.
3
Rotate the control dial to adjust the
listening position, then press it.
Adjustable range: "+3" – "CENTER" – "–3."
4
Press (BACK).
The display returns to normal reception/play
mode.