Attaching The Covers - Epson BrightLink 575Wi Guide D'installation

7 Attaching the Covers

A
Attach the wall plate cover and end cap
If you need to use a security cable, make sure you attach it before installing the wall plate cover. See
page 42 for instructions.
You can use the included wall plate cover extender to increase the depth of the wall
plate cover and accomodate larger cables and plugs.
To add the extender, clip each half of the extender to the wall plate cover pieces before
you attach the cover to the mount.
Adding the wall plate cover extender limits the minimum size of the projected image.
See page 14 for more information.
1. Attach the wall plate cover (
need to remove the cover, press the tabs.)
Depending on how the cables are wired, you may need to cut out parts of the wall
plate cover to allow the cables to be passed through it.
When cutting the thin section of the wall plate cover and passing the cables through,
make sure you perform deburring to smooth off any sharp edges to prevent damaging
the cables.
Also, make sure you operate the cutter safely.
2. Place the end cap with the concave portion facing up (
End cap
). Snap the tabs on the cover into the holes on the wall plate. (If you
Wall plate cover
).
40