Faults And Fault Rectification - Salvis Smartline Série Mode D'emploi

en
8.

Faults and fault rectification

Check any faults in the appliance against the following table:
Fault
The green indicator
light does not illumi­
nate when switched
on.
The appliance does
not heat up and the
yellow indicator light
is off.
If you cannot remedy the fault,
‒ switch off the appliance and disconnect from the mains,
‒ do not open the housing,
‒ contact the authorised Customer Service agent.
30 / 72
Possible cause
Main switch before appliance
not turned on.
There is no power supply at
all.
Mains fuse has tripped.
The safety temperature limiter
has tripped.
Action
Turn on main switch.
Inform the power supply company.
Possible faults on the appliance must
be checked by an authorised Customer
Service agent.
Reset the circuit breaker.
Check to make sure that the tank is
sufficiently filled with deep-frying oil/fat.
Allow the appliance to cool.
WARNING! Fire danger! Do not switch
the safety temperature limiter back on
until the cause of the failure has been
rectified.
Push in the switch knob. Contact the
authorized Customer Service if the
fault recurs.
Switch knob for the safety temperature
limiter