Initial Use; Mains Connection - Beurer IL30 Mode D'emploi

• Do not touch the infrared lamp or unscrew it when it is connected to the mains.
• Children do not understand the risks associated with electrical appliances. Make sure the appliance is not
used by children without appropriate supervision.
• Keep children away from packaging materials (risk of suffocation).
• Do not cover up or pack away the unit while it is warm.
• Always remove the mains plug and let the unit cool off before you touch it.
• Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the
unit. The unit must be operated only when it is completely dry.
• Protect the unit from strong impacts.
• Do not pull the mains plug from the socket by the cord.
• In the event of a defect or malfunction, switch the device off immediately and disconnect it from the power
supply.
If the power cord of the device is damaged, it must be replaced by the manufacturer or an authorised
customer service technician in order to avoid hazard.
• Disconnection from the mains supply is only guaranteed if the mains plug has been removed from the socket.
General notes
Important
• Please note that it may be necessary to comply with additional requirements (e.g. the Medical Devices
Operator Ordinance) for commercial use.
• If you have health concerns of any kind, contact your doctor!
• Before you use the unit for the first time, remove all packaging materials.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• Please contact customer services should you have any issues with this product.

4. Initial use

Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.

Mains connection

Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
9