Oceanic OCEACLIM140W Guide D'utilisation page 57

Problems
The appliance works
but does not cool
the temperature
down.
The appliance works
but does not cool
the temperature
down.
Error code "E2" is
displayed on LED
screen.
Error code "E3" is
displayed on LED
screen.
Error code "E4" is
displayed on LED
screen.
Error code "E5" is
displayed on LED
screen.
Possible causes
- Verify if the set
temperature is higher than
the room temperature.
- Verify if a window or a
door is closed.
- Verify if any heater or
lamp is producing heat.
- Verify if the air filter is
dirty.
- Verify if the set
temperature is higher than
the room temperature.
- Verify if a door or a
window is opened.
- Verify
if any
producing appliance is in
use (a heater or lamp for
example).
- Verify if the air filter is
dirty.
- Verify if the air outlet is
blocked by any bulky
object.
- The room temperature
sensor does not work or is
damaged.
- The evaporator oil pipe
sensor may be damaged.
Please contact your after-
sales service.
- Water-tank-full warning.
- The condenser coil pipe
sensor may be damaged.
Please contact your after-
sales service.
56
Solutions
- Lower the set
temperature. (Please
refer to IV. Use.)
- Close the window or
door to stop hot air
from entering.
- Switch the(se)
appliance(s) off.
- Clean the filter.
(Please refer to V.
Maintenance and
cleaning.)
- Lower the set
temperature
- Stop hot air from
entering.
heat-
- Turn off these
appliances.
- Clean the filter.
- Remove the
obstacles.
- Replace the room
temperature sensor.
- Replace the
evaporator oil pipe
sensor.
- Drain the water tank.
- Replace the
consensor coil pipe
sensor.