Resetting The Cycle Counter To Zero - Hettich MIKRO 185 Mode D'emploi

EN
20.7

Resetting the cycle counter to zero

After the rotor has been exchanged, the cycle counter must be reset to zero again.
The cycle counter may only be reset to zero if the rotor has been exchanged for a new rotor first.
With the rotor at a standstill, the cycle counter can be reset as follows:
The procedure can be aborted at any time by pressing the
 Press and hold the button for eight
SELECT
seconds.

 Press the key until the following is
SELECT
displayed.

 Press the key.
START
PULSE

 Press the key until the following is
SELECT
displayed:
Cyc sum : Number of completed run
cycles.

 Press the key.
RCF

 Press the key.
t
The number of completed run cycles is
reset to zero.

 Press the button to save the setting.
START
PULSE

 Press the key twice to exit the "
STOP
OPEN
Cycles"
menu or press three times to exit the "
MACHINE MENU ".
70/146
STOP
OPEN
key. In this case, the settings are not stored.
>RCF< RPM
>RCF< RPM
Example:
RPM
>RCF<
RPM
>RCF<
>RCF< RPM
>RCF< RPM
>RCF< RPM
>RCF< RPM
Time &
>RCF< RPM
Rev. 05 / 05.2020
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
t/min:s
Example:
t/min:s >RCF< RPM
AB1203DEENFRIT
t/min:s