Cleaning Brewing Unit; Service Programmes - Siemens EQ 500 integral Série Notice D'utilisation

en Cleaning and servicing

Cleaning brewing unit

In addition to the automatic rinsing
process, regularly remove and clean
the brewing unit.
WARNING
Risk of burns!
Some parts of the appliance become
very hot.
Never touch hot appliance parts.
▶
Allow hot appliance parts to cool
▶
down before touching them.
ATTENTION!
The appliance may be damaged by
improper cleaning.
Do not use washing-up liquid.
▶
Do not use cleaning agents con-
▶
taining vinegar or acids.
Do not clean in the dishwasher.
▶
Press to switch the appliance
1.
off.
Open the door of the brewing
2.
chamber.
→ Fig.
20
Remove the drip tray with the cof-
3.
fee dregs container.
→ Fig.
21
Push the red lever upwards.
4.
Hold the brewing unit by the
5.
handle and carefully pull forwards
and out.
→ Fig.
22
66
Clean the brewing unit thoroughly
6.
under warm running water.
→ Fig.
23
Clean the appliance interior with a
7.
damp cloth and remove any coffee
residues.
Leave the brewing unit and the ap-
8.
pliance interior to dry.
Hold the brewing unit by the
9.
handle.
Push the red lever upwards.
10.
Position the brewing unit under the
11.
lever and slide it back as far as it
will go.
→ Fig.
24
a The lever will click into place.
Insert the drip tray with the coffee
12.
dregs container.
→ Fig.
25
Close the door.
13.
→ Fig.
26
The door can only be closed if the
brewing unit and drip tray are in-
serted correctly.

Service programmes

After certain time intervals, your appli-
ance will recommend that you use
the service programmes. Use the ser-
vice programmes to clean your appli-
ance thoroughly.
ATTENTION!
Improper cleaning and descaling or a
delay in doing so may damage the
appliance.
Immediately perform the descaling
▶
process in accordance with the in-
structions.
Do not put any descaling tablets or
▶
other products into the ground cof-
fee compartment.