Operation - LawnMaster CLGT2410 Guide D'utilisation

OPERATION

INTENDED USE
This grass trimmer CLGT2410 is with rated battery voltage of 24 V
the respective charger with a charging voltage of 24 V
The product is intended for cutting weed, grass or similar soft vegetation in areas that are hard to
reach, e.g. under bushes, on slopes and edges. It may not be used to work on unusual thick, dry or
wet grass, e.g. pasture grass, or to shred leaves.
This product is intended for private domestic use only, not for any commercial trade use. It must not
be used for any purposes other than those described.
ON/OFF SWITCH (SEE FIG. 18)
• Press the unlock button (4) on either side and
hold it in position.
• Press the on/off switch (3) to switch the product on
(Fig. 19).
• Release the on/off switch (3) to switch the product off.
ADJUSTING SHAFT LENGTH (SEE FIGS. 19-20)
Adjust the length to suit your height. We recommend always using the product with the pole fully
extended .
• Loosen the locking sleeve (10)
in an counterclockwise direction.
• Pull the telescopic shaft (11)
to desired length.
• Tighten the locking sleeve
(10) in a clockwise direction.
ADJUSTING POWER HEAD ANGLE (SEE FIGS. 21-23)
Adjust the angle of the trimmer head (14) according to the intended operation.
• Pull the Angle adjustment button (9) backward and hold it in position (Fig. 21).
• Adjust to desired position: Adjust to 0° when trimming grass on flat ground (Fig. 21). Adjust to
90° or 180° when trimming near edges and walls (Fig. 22, 23).
• Ensure that the Angle adjustment button (9) snaps in place.
fully extended
Fig. 19
14
. 24LSC01-ETL designates
.
4
3
Fig. 18
Fig. 20
Retracted