Maintenance And Service; Maintenance And Cleaning - Bosch PSS 300 AE Notice Originale

OBJ_BUCH-62-003.book Page 13 Thursday, October 17, 2013 4:30 PM
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of primers
before coating
Replacing the Sanding Plate
The sanding plate 5 can be replaced, if required.
Unscrew the 6 screws 11 completely and remove the sanding
plate 5. Attach the new sanding plate 5 and tighten the screws
again.
11
5
Operation
Starting Operation
 Observe correct mains voltage! The voltage of the pow-
er source must agree with the voltage specified on the
nameplate of the machine. Power tools marked with
230 V can also be operated with 220 V.
Switching On and Off
To start the machine, push the On/Off switch 2 towards the
front to "I".
To switch off the machine, push the On/Off switch 2 towards
the rear to "0".
To save energy, only switch the power tool on when using it.
Preselecting the Orbital Stroke Rate
With the thumbwheel for preselection of the orbital stroke
rate 1, you can preselect the required orbital stroke rate, even
during operation.
The required stroke rate depends on the material and the
working conditions and can be determined through practical
testing.
Bosch Power Tools
Working Advice
Grain size
 Prevent dust accumulation at the workplace. Dusts can
40—320
 Wait until the machine has come to a standstill before
 Before any work on the machine itself, pull the mains
coarse 40, 60
The removal capacity during sanding is mainly determined by
medium 80, 100, 120
the selection of the sanding sheet as well as the preselected
orbital stroke rate.
fine 180, 240, 320
Only flawless sanding sheets achieve good sanding capacity
and extend the service life of the machine.
Pay attention to apply uniform sanding pressure; this increas-
es the working life of the sanding sheets.
Intensifiying the sanding pressure does not lead to an in-
crease of the sanding capacity, but to increased wear of the
machine and the sanding sheet.
A sanding sheet that has been used for metal should not be
used for other materials.
Use only original Bosch sanding accessories.

Maintenance and Service

Maintenance and Cleaning

 Before any work on the machine itself, pull the mains
 For safe and proper working, always keep the machine
If the replacement of the supply cord is necessary, this has to
be done by Bosch or an authorized Bosch service agent in or-
der to avoid a safety hazard.
After-sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions
concerning our products and their accessories.
In all correspondence and spare parts order, please always in-
clude the 10-digit article number given on the type plate of
the machine.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: (0844) 7360109
Fax: (0844) 7360146
E-Mail: boschservicecentre@bosch.com
easily ignite.
placing it down.
plug from the socket outlet
plug.
and ventilation slots clean.
2 609 007 641 | (17.10.13)
English | 13