Genesis GPCS535KM Manuel D'utilisation page 11

Repositioning the Miter Angle Scale and Base (FIG 10)
for increased versatility, the miter angle scale and base can be
fitted to either side of the track and positioned anywhere along
the length of the track.
1. Loosen the lock knob (29) underneath the miter base.
2. Slide the miter scale and base along the track to desired
position.
3. fasten the lock knob to secure its position.
OPErATION
WArNING:
important safety warning and instructions before using this tool.
WArNING:
before making any adjustments or setting up prior to cutting. Failure to disconnect or
unplug the tool may cause accidental starting, resulting in serious personal injury.
NOTE:
Always check that the power supply corresponds to the voltage on the ratings plate.
STARTING AND STOPPING THE TOOL
To Start the Tool
1. Push the lock-off button forward with the index finger.
1
See in fIG 11.
2. Depress ON/Off trigger switch firmly inwards and keep it
pressed at the same time. See 2 in fIG 11.
To Stop the Tool,
release the ON/Off trigger switch.
WArNING:
rotate after the tool is switched off.
RELEASING THE PLUNGE STOP
1. Press the rear portion of the plunge release button downwards and keep it pressed. See 3 in fIG 11.
2. Raise the body of the saw to plunge the blade into the workpiece.
NOTE:
Pressing the plunge release button unlocks the plunge cut mechanism at the same time, so that the
saw head can be moved downwards, and the saw blade emerges from the tiltable protective cover.
USING THE LASER FEATURE
WArNING:
the laser beam. Do not point the laser beam at other people or animals, either directly or
through reflective surfaces.
The laser feature on your saw is powered by two LR44 1.5V button batteries (installed). The Laser feature clearly
shows you an extended cut-line, even over debris on the work piece. Turn it on with the laser light ON/Off switch
right before cutting. Turn it off immediately after use to conserve battery and laser life.
FOLLOWING A CUT LINE (FIG 12)
Pointers (7a,7b) at the front and rear of the base plate allow you to
follow a pre-marked cut line in your workpiece.
POWER-ON INDICATOR
The tool is equipped with a Power-On Indicator. It lights up when
the tool is connected to a power source.
To reduce the risk of serious personal injuries, read and follow all
Always be sure the tool is disconnected from the power source
The saw blade continues to
Laser light can cause severe eye damage. Never look directly into
FIG 10
FIG 11
3
FIG 12
7a
29
2
1
7b
11