Tecno-gaz ONYX B 5.0 Mode D'emploi page 58

ENGLISH
1. Install the autoclave in environments suitable to sterilization.
2. The premises have to be suitably lit and ventilated, in compliance with regulations in
force.
3. Install the autoclave away from heat sources and water splashes.
4. Position the autoclave on a surface, suitable to support the weight (80 Kgs.) and with
adequate dimensions.
5. Place the autoclave at a height allowing easy intervention by the operator for inspection
and clearing of the whole sterilization chamber.
6. Open the door of the autoclave and remove all packages containing the single
accessories from inside the sterilization chamber.
7. Leave inside the sterilization chamber only the tray carrier with the trays. All other
accessories should be positioned in a separate space available to operators.
8. Don't put anything on the autoclave.
9. Do not lean on the door.
10. Leave a space of at least 5 cm in the rear of the autoclave, using the spacer
(Fig.A–pos. 0 / Fig.8) and in the sides of the unit to ensure the ventilation required.
11. Make connections of supplied pipes in the back (chapter 7).
12. Always make sure the electrical system to which the autoclave is to be connected is in
conformity with the legislation in force and sized to suit the specifications of the said
device.
13. Connect the power supply cord to the socket on the rear panel of the autoclave
(Fig.A–pos. 5 ).
14. Connect the electrical plug to the system ensuring that it is adequate to the supply of the
machine.
Do not use extensions, reducers or adapters for connection as this could
NOTE:
cause micro interruptions with consequent generation of alarm signals.
15. Turn the autoclave on by pressing the mains switch (Fig.A-pos.
of the autoclave itself. Wait a few seconds, there will be two acoustic signals to inform
you of the acquisition of the parameters for the automatic barometric alignment, at the
same time the text DOOR OPEN will appear on the display.
Never select a command before hearing the two sound signals, the
NOTE:
autoclave will not accept the chosen programming.
14
10 ) and open the hatch