Tecno-gaz ONYX B 5.0 Mode D'emploi page 45

1. INTRODUCTION
2. USE AND DESTINATION OF USE OF THE AUTOCLAVE
3. SAFETY
3.1
SAFTY MARKING
3.2 SAFETY DEVICES
3.3 SAFETY NOTES
3.4
DISPOSAL
4. TECHNICAL DATA
5. OUTPUTS AND INDICATORS LIST
6. UNPACKAGING
7. ACCESSORIES
8. INSTALLATION
9. PROGRAMMING DISPLAY
10. USE INSTRUCTION
10.1 TURNING ON THE AUTOCLAVE AND BAROMETRIC ALIGNMENT
10.2 CLEAN WATER TANK MANUAL LOAD
10.3 CHARACTERISTICS OF THE WATER TO BE USED
10.4 LOADING OF THE MATERIALS INTO THE AUTOCLAVE
10.5 STARTING THE STERILIZATION CYCLE
10.6 END OF THE STERILISATION CYCLE
10.7 UNLOADING OF THE STERILIZED MATERIALS
10.8 DISCHARGING USED WATER
10.9 INTERRUPTION OF A STERILIZATION CYCLE
11. STERILIZATION CYCLES
11.1 DESCRIPTIONS CYCLES
11.2 OPERATION CYCLES
11.3 NIGHT CYCLES
11.4 TEST CYCLES
11.5 CYCLE DIAGRAM
12. SOFTWARE VISUALIZATION CYCLES
12.1 INSTALLATION
12.2 LANGUAGE SETTING
12.3 SINGLE LOG FILE VIEWING
12.4 OPEN DIRECTORY
12.5 MAKE REPORT
12.6 MAKE PDF
12.7 MAKE FOLDER PDF
13. OSMOSI SYSTEM INSTALLATION
INDEX
ENGLISH
1