Advance ecoflex SC500 9087352020 Instructions D'utilisation page 17

NOTE
For the first 3 flow levels (Fig. 4), the amount of solution dispensed is automatically adjusted according to the machine
speed, in order to obtain a constant amount of solution per linear meter of cleaning.
Level 4 (when enabled) supplies the maximum possible quantity of detergent solution, regardless of the machine speed
(to enable or disable this, see the Super User key section in the Maintenance chapter).
The level 0 closes the solution flow completely.
Lev.
1
Disc 0,75 cl/m
REV™ 0,38 cl/m
6. If necessary, to reduce the noise, turn on the mute function by pressing the switch (48).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in figure 6.
CAUTION!
To avoid any damage to the floor surface, turn off the brush when the machine is stationary, especially when the
extra pressure function is on.
7. At the end of the work, press the push-button (43) to lift the brush deck. After 10 seconds, the vacuum system turns off too.
8. Lift the squeegee (29) with the pedal (8).
Adjusting of detergent concentration in the washing
water
(For machines with EcoFlex™ system)
The system for mixing the detergent in the washing water is
automatically activated when the brush is running.
The percentage of detergent added to the washing water is set
to level 1 (Fig. 7).
By pressing the push-button (50), it is possible to set the
percentage level to 2, or reset it to level 0.
The set percentages are shown on the multifunction display
(51-H).
11/2014
Lev.
2
1,5 cl/m
0,75 cl/m
A
INSTRUCTIONS FOR USE
Lev.
4
Lev.
3
3,0 cl/m
1,5 cl/m
Figure 5
B
Figure 6
Lev.
1
9099980000 - SC500
Lev.
0
2,8 l/min
Lev.
2
Lev.
0
Figure 7
ENGLISH
OFF
P100858
P100845
OFF
P100846
15