Technical Data - Bosch GAS 15 Professional Notice Originale

OBJ_BUCH-3283-001.book Page 10 Friday, July 7, 2017 11:42 AM
10 | English
28 Clips for securing the plastic bag
29 Filter holder
30 Filter basket
31 Air diffuser

Technical Data

Wet/dry vacuum cleaner
Article number
Rated power input
Frequency
Container volume (gross)
Net volume (for fluids)
Dust bag contents
*
Max. vacuum pressure
– Dust extractor
– Turbine
*
Max. flow rate
– Dust extractor
– Turbine
Automatic Start/Stop feature
Weight according to EPTA-Procedure 01:2014
Protection class
Degree of protection
* Measured with a Ø 35 mm and 3 m long vacuum hose
The values given are valid for nominal voltages [U] of 230 V. For lower voltage and models for specific countries, these values can vary.
Automatic Start/Stop feature*
max. power
Rated voltage
JP 100 V
TW 115 V
CN 220 V
High
voltage 220–240 V
* Specification of the allowable load of the connected power tool
(country-specific)
Assembly
 Before any work on the vacuum cleaner itself, pull the
mains plug.
Mounting VAC Accessories (see figure A)
The vacuum hose 17 is equipped with a clip system, with
which the VAC accessories (tool sleeve 14, elbow 17) can be
connected.
Mounting the Tool Sleeve (GAS 15 PS)
– Mount the tool sleeve 15 onto the vacuum hose 17 until
both snap-fasteners 27 of the vacuum hose can be heard
to engage.
– To disassemble, press both snap-fasteners 27 inward and
pull the components apart.
1 609 92A 404 | (7.7.17)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
W
Hz
l
l
l
kPa
kPa
l/s
l/s
kg
Mounting Nozzles and Tubes
– Mount the elbow 18 onto the vacuum hose 17 until both
min. power
snap-fasteners 27 of the vacuum hose can be heard to en-
output output
gage.
1050 W 100 W
– Afterwards, mount the desired VAC accessory (floor noz-
1050 W 100 W
zle, crevice nozzle, vacuum tube, etc.) firmly onto the el-
bow 18.
1100 W 100 W
– To disassemble, press both snap-fasteners 27 inward and
pull the components apart.
2200 W 100 W
Mounting the Vacuum Hose
Vacuuming function (see figure B1)
– Insert the vacuum hose 17 into the hose connection piece
2 and turn it all the way in clockwise direction.
Note: While vacuuming, an electrostatic charge develops in
the vacuum hose and accessories caused by the friction of the
dust, which the operator could experience in the form of stat-
ic discharging (dependent on environmental influences and
physical perception).
As a general rule, Bosch recommends using an anti-static vac-
uum hose (accessory) when vacuuming fine dusts and dry
materials.
GAS 15 GAS 15 PS
3 601 JE5 0.. 3 601 JE5 1..
1100
50/60
15
8
8
22
27
33
53
–
9,6
/II
IP X4
Bosch Power Tools
1100
50/60
15
8
8
22
27
33
53

9,6
/I
IP X4