How To Use The Core Bit (For Light Load) - Hitachi DH 30PC2 Mode D'emploi

English
9. Using the side handle
When you wish to change a position of the side handle, turn grip of the side
handle counterclockwise to loosen it, and then fasten it firmly.
CAUTION:
When boring a hole, there can be a case where the machine attempts to rotate
by the reaction at the time of penetrating a concrete wall and/or when a tip of
the blade comes in contact with the rebar.
Firmly fasten the side handle and hold the machine with both of your hands.
Unless you hold it securely, an accident can occur.

HOW TO USE THE CORE BIT (FOR LIGHT LOAD)

When boring penetrating large hole use the core bit (for light load). At that time use
with the center pin and the core bit shank provided as optional accessories.
1. Mounting
CAUTION:
Be sure to turn power OFF and discon-
nect the plug from the receptacle.
(1) Mount the core bit to the core bit shank.
(Fig. 14)
Lubricate the thread of the core bit
shank to facilitate disassembly.
(2) Mount the core bit shank to the rotary
hammer. (Fig. 15)
(3) Insert the center pin into the guide plate
until it stops.
(4) Engage the guide plate with the core
bit, and turn the guide plate to left or
right so that it does not fall even if it
faces downward. (Fig. 16)
14
Core bit
Core bit shank
Fig. 14
Fig. 15
Center pin
Core bit
Fig. 16
Thread
Guide plate
Core bit tip