EHEIM proxima 175 Mode D'emploi page 9

GB
Remove any foreign matter such as dust, sand, etc. from the underside of the aquarium base
and the top of the furniture.
Place the aquarium on the furniture. Do not place any mats / underlays between the aquarium
and the furniture.
C Set-up
Clean pool: the aquarium must be cleaned thoroughly with warm water and a soft, clean
sponge before installation.
Do not use any detergents!
Tip: Before setting up, perform a test fill and check that it is watertight.
Tip: EHEIM information booklets covering installation, plants and fish are available in
specialist retailers or at
C: Maximum water level
The aquarium must not be filled any more than 10mm above the lower edge of the decorative
stripe .
There must be a gap of at least 15mm between the lights and the surface of the water!
C: Supporting surfaces
Sliding surfaces  and  must be kept clean to ensure a clean sliding movement of the glass
cover panes and to prevent damage.
C: Cover panels
Fit the cover panels to the sliding surfaces.
The cover panel that is shorter at the bottom runs on the lower tread of the rail and the longer
one on the upper tread.
D Changing the fluorescent tubes
If one tube is defective, both fluorescent tubes will automatically shut down.
If the lights still don't start after replacing the suspected defective fluorescent tube, please
check if the defective tube was changed or not.
Disassembly:
D. Disconnect from mains power & loosen end caps
D. Push end caps over the tube
D. Pull tubes out forwards without rotating
Assemble by following instructions in reverse order.
During assembly, make sure that everything is positioned correctly and tighten the end caps
evenly by hand.
www.eheim.com