EHEIM incpiria 200 Mode D'emploi page 12

GB
C Process
1. Remove any foreign matter from the surface around the hole in the aquarium bed to
maintain a perfect seal surface
2. Insert the standpipe conduit  from above into the hole in the aquarium bed  with
seal applied 
3. Check that the base of the seal  is clean
4. Secure the standpipe conduit  from below by tightening the locking nut 
5. Connect the filter drainage hose  (Ø16/22; not included) to the hose connector 
and fasten the safety mechanism 
6. Assemble hose connector , with the flat gasket inserted in the union nut, screw on
to the thread of the standpipe conduit from below
7. Attach inlet filter  to the standpipe conduit
D Set-up
Clean pool: the aquarium must be cleaned thoroughly with warm water and a soft, clean
sponge before installation.
Do not use any detergents!
Tip: Before setting up, perform a test fill and check that it is watertight.
Tip: EHEIM information booklets covering installation, plants and fish are available in
specialist retailers or at www.eheim.de
D: Maximum water level
The aquarium must not be filled any more than 10mm above the lower edge of the decorative
stripe .
There must be a gap of at least 15mm between the lights and the surface of the water!
D: Supporting surfaces
Sliding surfaces  and  must be kept clean to ensure a clean sliding movement of the glass
cover panes and to prevent damage.
D: Cover panels
Fit the cover panels to the sliding surfaces.
The cover panel that is shorter at the bottom runs on the lower tread of the rail and the longer
one on the upper tread.
E Fine adjustment of doors
If necessary, the doors can be readjusted as illustrated.
The doors can be quickly disassembled / assembled as illustrated using the quick release
function.