Transporting And Storing - Milwaukee 2739-20 Manuel De L'utilisateur

24. Trigger
25. Trigger lock
26. Cut-line indicator switch (not shown)
27. Dust chute
28. Dust bag
29. Slide rail lock
37
36
SPECIFICATIONS
Cat. No. ..................................................... 2739-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Recommended Ambient
Operating Temperature ..................... 0°F to 125°F
No Load RPM ..................................................3600
Arbor Size ......................................................... 5/8"
Blade Size ......................................................... 12"
Blade Thickness (Kerf) ............................. Max 1/8"
Weight .......................................................47.6 lbs.
CAPACITIES
Miter Cuts
Max Height ..................................................... 3.8"
Max Width at 0° Miter.................................... 13.4"
Max Width at 45° Miter .................................. 9.3"
Bevel Cuts
Max Height at 0° Bevel ................................... 3.8"
Max Height at Left 45° Bevel .......................... 2.5"
Max Height at Right 45° Bevel ....................... 1.6"
Compound Cuts (45° Miter and 45° Bevel)
Left .............................................. 9.3" W at 2.5" H
Right ............................................ 9.3" W at 1.6" H
Workpiece Vertical Against Fence
0° Miter / 0° Bevel ........................ 1.1" W at 6.8" H
Left 45° Miter / 0° Bevel ............... 0.6" W at 6.8" H
Right 45° Miter / 0° Bevel ............ 0.6" W at 6.8" H
24
35
34
5
30. Bevel knob
31. 0° stop pin
32. Hand stop
33. Wrench storage (not shown)
34. 6 mm Hex Wrench
25
35. Workpiece clamp sockets (2)
36. Spindle lock
26
37. Handle
38. Kickstand
32
33
ASSEMBLY
Installing the Carrying Handles
The carrying handles are used for transport as well
as support extensions for cutting longer workpieces.
Use the four bolts to attach the carrying handles to
each side of the miter saw table, using the blade
wrench provided. Tighten securely.
Always lock the slide rails and lock down the saw
head before transporting tool. Only carry tools by
the carrying handles.
Installing the Kickstand
Lay the miter saw on its side. Insert the kickstand
(the bend should angle toward the ground) into the
two holes under the slide rails. Push the kickstand
in until it won't go any further. To secure, insert and
tighten the screw into the end of one kickstand prong.

Transporting and Storing

Always lock the saw head and slide rails before
transporting and storing the tool. Only carry tools by
the carrying handles.
Saw Head
To lock, press and hold down the saw head and then
push in the lock-down pin.
To unlock, press and hold down the saw head and
pull out the lock-down pin. Raise the saw head.
Slide Rails
To unlock, loosen the slide rail lock by turning it
counterclockwise.
To lock, slide the saw head forward and tighten the
slide rail lock by turning it clockwise.
28
27
31
38
29
30