Controlling Another Cd Player (Mega Control) - Sony CDP-CE515 Mode D'emploi

Playing CDs
Controlling Another CD Player
(Mega Control)
This unit can control a second CD player (see
"Connecting Another CD Player" on pages 6 and 7).
Even when a second CD player is connected, the
controls on both of the units will function. When you
press the play button on either unit, the operating
player stops and the resting player starts.
The controls indicated in the illustration below are effective
while the MEGA CONTROL button is lit.
Play mode buttons (CONTINUE/
SHUFFLE/PROGRAM/REPEAT)
1
Press MEGA CONTROL on this player.
The MEGA CONTROL button lights up and the
display shows the current disc number of the
second player.
Current disc number
ALL DISCS
DISC
* D I S C - 1 *
2
Select the play mode you want.
To program tracks, use the controls on the second
player.
3
Press · on this player to start playing.
The play starts and the display shows the current
disc and track numbers and the playing time of the
track.
While the MEGA CONTROL button is lit, you can
control the second player with the controls on this
player as follows:
EN
18
≠
(DISC)
· P p
0 (–AMS+) ) MEGA CONTROL
CD1
To
Pause
Stop play
Locate a disc while
the second player is
set to Continuous
Play mode
Locate a track
• To do other operations, use the controls on the second
player or the supplied remote.
AMS
±
• The AMS buttons (=/+) and search buttons
(0/)) on the remote operate the second player as
indicated on the remote.
To control the second player directly using the supplied
remote
Set CD 1/2/3 on the remote to CD 3 which is the same
position as the COMMAND MODE selector on the rear panel
of the second player.
To control this player again
Press MEGA CONTROL. The MEGA CONTROL button goes
off and you can control this player.
Notes
• You cannot locate a particular point in a track of the second
player using the controls on this player.
• Some controls on this player work on the second player
differently from they do to this player.
You need to
Press P
Press p
AMS
Turn ≠ ± until the
(DISC)
display shows the disc number
you want, then push
AMS
≠ ±
(DISC)
Press 0 (–AMS+) ) until the
display shows the track number
you want