Creating Your Own Program (Program Play) - Sony CDP-CX88ES Mode D'emploi

Playing all tracks on all discs in random
order
1
Press SHUFFLE.
"ALL DISCS" and "SHUFFLE" appear in the
display.
2 Press ENTER or ·.
ALL DISCS Shuffle Play starts.
" " appears in the display while the player is
"shuffling" the discs or the tracks.
Playing all tracks on a specified disc in
random order
1
Press SHUFFLE twice.
"1 DISC" and "SHUFFLE" appear in the display.
2
Turn the JOG dial until the desired disc number
appears in the display.
When using the remote, first press DISC, then
press the number button of the disc.
3 Press ENTER or ·.
When using the remote, press ENTER.
1 DISC Shuffle Play starts.
" " appears in the display while the player is
"shuffling" the tracks.
To cancel Shuffle Play
Press CONTINUE.
You can start Shuffle Play while playing
Press SHUFFLE, and Shuffle Play starts from the current
track.
You can go to the next disc during 1 DISC Shuffle Play
Press DISC SKIP +.
You can specify the next disc to play during 1 DISC
Shuffle Play
Turn the JOG dial to specify the next disc. After all the
tracks on the current disc are played in random order,
the next disc starts playing. If you want to skip to the
next disc right away, press ENTER while playing the
current disc.
Notes
• You cannot specify the next disc to play during ALL DISCS
Shuffle Play.
• Even if you press p or turn off the player during ALL
DISCS Shuffle Play, the player remembers which discs or
tracks were played and which were not. Therefore, if you
want to start ALL DISCS Shuffle Play again from the
beginning, be sure to repeat the procedure from Step 1.
Getting Started Playing CDs
Creating Your Own Program
(Program Play)
You can arrange the order of the tracks and/or discs to
create three different programs which are stored
automatically. A program can contain up to 32 "steps";
one "step" may contain a track or a whole disc.
You can make programs using the controls on the
remote as well as ones on the player. However, the
programming procedures are different.
Creating a program on the player
≠/±
PROGRAM
1
Press PROGRAM until the desired program
number (PROGRAM 1, 2 or 3) appears in the
display.
If a program is already stored in the selected
program number, the last step of the program
appears in the display. When you want to erase the
whole program, hold down CLEAR until "ALL
CLEAR" appears in the display (see page 22).
2
Turn the JOG dial until the desired disc number
appears in the display.
CD1
PROGRAM1
DISC
*DISC-2O*
3
To program a whole disc, skip this step.
Press ≠/± until the desired track number
appears in the display.
CD1
PROGRAM1
DISC TRACK
2O 3
Track number
Playing CDs Playing CDs
ENTER JOG CHECK
·
CLEAR
2O
2O
STEP
1
(Continued)
EN
21