Led Light - Makita DSC102 Manuel D'instruction

LED light

CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 15 seconds after
releasing the switch trigger.
► 1. Lamp (inside)
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: When the tool is overheated, the lamp will
blink. Let the tool cool down in this case.
Guide scale
Use the guide scale if you wish to cut threaded rods in
the same length. Insert the guide scale into the hole as
shown in the figure.
2
► 1. Guide scale 2. Clamping screw
Align the value of your desired length on the guide scale
with the cutting line. Then tighten the clamping screw.
2
1
► 1. Guide scale 2. Cutting line 3. Clamping screw
CAUTION:
carry or handle the tool. The tool may fall off and
cause personal injury and/or damage to the tool.
Rod guide
For a precise cutting, set the rod guide in position
depending on the diameter of the threaded rod to be
cut.
1
► 1. Rod guide (Position 1) 2. Rod guide (Position 2)
There are two rod guide positions.
Position
1
2
8 ENGLISH
Do not hold the guide scale to
1
Size of threaded rod
W3/8, 3/8-16UNC, M10
W5/16, W1/4, 5/16-18UNC, 1/4-20UNC,
M8, M6
1
3
2