Makita DSC102 Manuel D'instruction page 11

When cutting, place the threaded rod perpendicular to
the cutting line as shown in the figure.
1
► 1. Cutting line
NOTE: When cutting a threaded rod made of ductile
metal such as stainless steel, burrs may be generated
on the cut end. Remove burrs with a file in this case.
► 1. Threaded rod 2. Burr
1
2
11 ENGLISH
Cutting secured threaded rods
When cutting a threaded rod which is secured to the building struc-
ture such as the ceiling, wall, floor, etc., follow the procedure below :
► 1. Threaded rod 2. Cutting die on the stationary mount
1.
Bring the tool so that the threaded rod is posi-
tioned between the cutting dice.
2. While the threaded rod contacting with the rod
guide, fit the thread of the rod with that of the cutting die
on the stationary mount.
3. Pull and hold the switch trigger until the cutting is finished
and the jaw of the cutting dice comes to fully opened position.
NOTICE:
Clean the front face of the tool and the
tip of the guide scale before operation. They may
dirty the contacting surface.
Cutting loose threaded rods
When cutting a loose threaded rod on the floor or a
work table, follow the procedure below :
► 1. Threaded rod 2. Cutting die on the stationary mount
1.
Position a threaded rod between the cutting dice.
2. While the threaded rod contacting with the rod
guide, fit the thread of the rod with that of the cutting die
on the stationary mount.
1 2
1 2