Makita DSC102 Manuel D'instruction page 10

Installing the cutting dice
CAUTION:
Always install the cutting dice in
the correct directions and secured firmly. Incorrect
or loose attachment may cause breakage of the cutting
dice, resulting personal injury by flown off fractions.
NOTICE:
Remove the burr on the cutting dice
using a file if any.
1. Check if the jaw of the cutting dice is fully opened.
If not, install the battery and pull the switch trigger until
the jaw is fully opened.
CAUTION:
Be sure to remove the battery
cartridge if you installed.
2.
Set the reversing switch lever to the lock position.
► 1. Reversing switch lever
3.
Unscrew the bolts with the supplied hex wrench.
CAUTION:
Use only the Makita wrench provided
with the tool. Using other wrenches may result in overtight-
ening or insufficient tightening which causes personal injury.
4. Set the cutting dice onto the mounts so that the
two colored markings can be seen.
3
2
5
6
► 1. Bolt 2. Cutting die 3. Stationary mount 4. Movable
mount 5. Colored marking 6. Hex wrench
1
1
4
5. Secure the cutting dice with the bolts firmly.
The cutting dice are correctly installed if the arrows on
them point each other. The dimensions of the cutting
dice are the same but their thickness look different
when seen from above.
3
► 1. Arrow 2. Cutting die 3. Thin side 4. Thick side
OPERATION
CAUTION:
the cutting dice are installed to the tool. Check
the cutting capacity written on the the cutting dice
before cutting.
CAUTION:
be sure to set the threaded rod so that its thread
fits with those of cutting dice. Incorrect alignment
1
of the threads may break the cutting dice and cause
2
personal injury by flown off fractions.
CAUTION:
cutting edge is chipped or deformed.
10 ENGLISH
1
2
Make sure that the correct size of
Before pulling the switch trigger,
Replace the cutting dice if the
4