Makita DSC102 Manuel D'instruction page 12

3. Pull and hold the switch trigger until the cutting is
finished and the jaw of the cutting dice comes to fully
opened position.
When cutting a long threaded rod which is hard to hold
by hand, place the tool as illustrated. The tool can be
placed flat. The cover also can be used for supporting
the end of the threaded rod.
► 1. Cover (Position 1) 2. Rod guide (Position 1)
3. Cover (Position 2) 4. Rod guide (Position 2)
The cover has markings to indicate its position.
Depending on the size of the threaded rod, put the
cover in the position as shown in the table as well as the
rod guide.
Position
1
2 W5/16, W1/4, 5/16-18UNC, 1/4-20UNC,
Quitting the cutting in the middle
CAUTION:
Never try to pull out the tool forci-
bly from the threaded rod. It may cause unexpected
start up which cause personal injury or damage to the
cutting dice and tool.
When quitting the cutting in the middle, set the revers-
ing switch lever to the reversing position and pull the
switch trigger until the threaded rod is completely
released from the cutting dice.
1
3
Size of threaded rod
W3/8, 3/8-16UNC, M10
M8, M6
MAINTENANCE
CAUTION:
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Replacing the cutting dice
2
NOTICE:
Replace the both cutting dice at the
same time. Replacing the one side of the cutting die
may generate burr on the threaded rod.
Replace the cutting dice when it is chipped, deformed,
or the cutting gets dull. To replace, follow the instruc-
tions in "Installing the cutting dice".
1
4
► 1. Chipping 2. Deformation
One cutting die has two cutting edges and thick side
and thin side. Switch the installation positions of the
cutting dice if you have not used the other sides of the
cutting edges.
► 1. Cutting edge 2. Thin side 3. Thick side
12 ENGLISH
Always be sure that the tool is
2
3
2
1