AEG IAE84881XB Notice D'utilisation page 14

The function deactivates automatically. To
deactivate the function manually select the
zone and change its heat setting.
For maximum duration values,
refer to "Technical data".
6.6 OptiHeat Control(3 step
Residual heat indicator)
WARNING!
III / II / I As long as the indicator
is on, there is a risk of burns
from residual heat.
The induction cooking zones produce the
heat necessary for the cooking process
directly in the bottom of the cookware. The
glass ceramic is heated by the heat of the
cookware.
The indicators III / II / I appear when a
cooking zone is hot. They show the level of
the residual heat for the cooking zones you
are currently using.
The indicator may also appear:
• for the neighbouring cooking zones even
if you are not using them,
• when hot cookware is placed on a cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
6.7 Timer
Count Down Timer
+STOP
Use this function to specify how long a
cooking zone should operate during a single
cooking session.
You can set the function for each cooking
zone separately.
1. Set the heat setting for the appropriate
cooking zone first and then set the
function.
2. Touch the zone symbol.
3. Touch .
The timer menu window appears on the
display.
14 ENGLISH
4. Check to activate the function.
The symbols change to
5. Slide your finger to the left or right to
select the desired time (e.g. hours and/or
minutes).
6. Touch OK to confirm your selection.
You can also choose
selection.
When the time comes to an end, a signal
sounds and blinks. Touch
signal.
To deactivate the function set the heat
setting to 0. Alternatively, touch
of the timer value, touch
confirm your choice when a pop-up window
appears.
Minute Minder
You can use this function when the hob is
activated but the cooking zones do not
operate.
The function has no effect on the operation of
the cooking zones.
1. Select any cooking zone.
The relevant slider appears on the display.
2. Touch .
The timer menu window appears on the
display.
3. Slide your finger to the left or right to
select the desired time (e.g. hours and
minutes).
4. Touch OK to confirm your selection.
You can also choose
selection.
When the time comes to an end, a signal
sounds and blinks. Touch
signal.
To deactivate the function touch
of the timer value, touch
confirm your choice when a pop-up window
appears.
.
+STOP
to cancel your
to stop the
to the left
next to it and
to cancel your
to stop the
to the left
next to it and