Milwaukee 5262-21 Manuel De L'utilisateur page 6

Warning
always unplug tool before changing or re-
moving accessories. Only use accessories
specifically recommended for this tool. Oth-
ers may be hazardous.
Warning
always use a side handle when using this tool.
Always brace or hold securely.
Adjusting the Side Handle Position
1. Loosen the side handle by unscrewing the side
handle grip until the side handle rotates freely.
2. Rotate the side handle to the desired position.
3. Tighten the side handle grip securely.
Setting the Depth Gauge
1. Press in the clamping lever.
2. Slide the depth gauge rod backward or forward
until it is set for the desired depth.
NOTE: The drilling depth is the distance between
the tip of the bit and the tip of the rod.
3. Release the clamping lever.
Warning
do not grasp the bit while the chuck is rotat-
ing or while the bit is falling from the chuck.
Warning
always unplug tool before attaching or remov-
ing accessories or making adjustments. Use
only specifically recommended accessories.
Others may be hazardous.
Warning
wear safety goggles or glasses with side
shields.
Warning
keep hands and cord away from the bit and
all moving parts.
Selecting Action
These MILWAUKEE Rotary Hammers have three
settings: rotation only, rotary hammer, and ham-
mer only. Always allow the motor to come to a
complete stop before changing the mode selection
to avoid damage to the tool.
1. For rotation only, press in
the selector release button
and turn the selector lever
so the arrow on the lever
points to the twist drill
symbol.
To reduce the risk of injury,
To reduce the risk of injury,
To reduce the risk of injury,
To reduce the risk of injury,
To reduce the risk of injury,
To reduce the risk of injury,
assembly
Installing Drill Bits and Chisels
Only use accessories with SDS or SDS Plus shanks.
Be sure that the shank of the bit is clean. Dirt par-
ticles may cause the bit to line up improperly. Do not
use bits larger than the maximum recommended
capacity of the drill because gear damage or mo-
tor overloading may result. For best performance,
be sure that the bit is properly sharpened and the
shank is lightly greased before use.
1. Insert the bit or chisel into the nose of the tool.
2. Rotate bit slowly until it aligns with the locking
mechanism.
3. Push bit into tool until it locks.
4. Check that the bit is locked properly; it should
be possible to pull the bit back and forth slightly
(about 1/4").
5. To remove bits and chisels,
pull bit holder release collar
toward the rear of tool and
remove bit.
NOTE: Use caution when
handling hot bits and chis-
els.
operaTion
2. For rotary hammering, press in the selector
release button and turn the selector lever so
the arrow points to the hammer and twist drill
symbol.
3. For hammering only, press in the selector release
button and turn the selector lever so the arrow
points to the hammer symbol.
4. To freely rotate the bit to the desired angle for
hammering only, press in the selector release
button and turn the selector lever to the
symbol. Then, follow step 3.
NOTE: To engage the hammering mechanism,
maintain pressure on the bit. When pressure on
the bit is released, the hammering action will stop.
6