Use - Miele Complete C3 Electro Plus Mode D'emploi

en
 Take out the accessory you require.
 Press down firmly on the lid to close
it.
AllTeQ floorhead (dia. 15)
For general use and also for vacuuming
the stairs.

For safety reasons when vacu-
uming stairs it is best to start at the
bottom of the stairs and move up-
wards.
Miele offer a range of other floor-
heads, brushes and accessories for
other types of flooring and special re-
quirements (see "Optional accessor-
ies").

Use

Unwind the mains cable (dia. 16)
 Pull the mains cable out to the re-
quired length (max. cable length ap-
prox. 7.5 m).
 Insert the plug into the socket cor-
rectly and switch on.

If vacuuming for longer than 30
minutes, the mains cable must be
pulled out to its fullest extent. Other-
wise there is a danger of overheating
and damage.
To rewind the cable (dia. 17)
 Switch off at the wall socket and re-
move the plug.
 Press the rewind foot switch briefly.
The cable will rewind automatically.
40
To switch on and off (dia. 18)
 Press the On/Off foot control .
To regulate the suction power
(dia. 19)
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to man-
oeuvre the floorhead.
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
 Curtains, fabric
 Upholstery, cushions
 Cut pile carpets, rugs and run-
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Loop pile carpet and rugs
 Hard flooring and heavily soild
carpets and rugs
When using the Electrobrush / floor-
head, if the suction seems too high,
reduce the suction until the Electro-
brush / floorhead is easier to man-
oeuvre.
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + foot control to select a
higher setting.