Malfunctions & Repairs; Display Malfunction Messages - Veromatic MBE01 Installation, Utilisation Et Entretien

7 Malfunctions & repairs
7.1

Display malfunction messages

This machine features advanced malfunction analysis. When something is wrong, a message will appear
on the display. Often the operator will be able to solve these malfunctions.
ATTENTION! The solution to the malfunction is only intended as a tip. You have to consult the extended
instructions in the relevant chapters of this manual to find the solution to this malfunction. If you cannot
solve the problem, please consult with your dealer.
Message type
Warning Machine requires service! Warning about the service date that is coming up
Warning Water filter dirty warning
Warning Brewer not in position
Busy Temperature too low
Busy Boiler is filling
Error Drip tray full
Error Boiler stopped filling
... container is empty
Error
Maintenance Service date reached
Maintenance Water filter saturated
Serious error Boiler error
Other malfunctions are listed below:
Malfunction
Machine only The canister is empty
delivers water
A canister is blocked
A mixing bowl is clogged
No Main power switch is off Turn main power switch on at the back of the
action/lightning
No mains voltage
Product is aqueous Bridging in the canister
or powder too old
Canister is almost empty Fill up the canister and reset the counter
Machine asks to Cup is not positioned
place a cup appropriately
A transparent cup is used
(these are not always
detected!)
Message
Warning about the water filter that needs a
replacement
(Re-)place brewer, waste bucket and close the door.
Wait for the boiler to reach the required temperature
Wait for the boiler to reach the minimum water level
Empty the drip tray
Restore water supply and restart the machine
Refill the container and reset the counter
Machine needs service from the operator
The water filter needs a replacement
Please call the operator
Possible cause
Fill the canister
Remove the blockage
Clean the mixing bowl
machine
Is the power cable attached appropriately?
Turn the canister once to loosen up the product
Position the cup appropriately
Use the glass function (see 5.1 point 6) or use an
opaque cup
67
Solution
Solution/Check
EN