Customization Of Bean Grind And Product Settings; Instructions For The Operator - Veromatic MBE01 Installation, Utilisation Et Entretien

Place the canisters back in the machine.
5
!
ATTENTION!
Mind that the outlets are turned downward inside the mixer.
Close the door.
6
Turn the machine on by means of the switch on the back of the machine.
7
The airbreak is empty, so will trigger the boiler filling procedure. Follow the instructions on the
8
display or the following:
Place a container (>1 L) underneath both the main outlet and the hot water outlet and press start.
9
The airbreak and the boiler will fill with water. After that a message 'Temperature too low' will appear
10
on the display.
Wait until the water in the boiler reaches the correct temperature. (The message 'Temperature too
11
low' disappears from the screen.)
Open the door of the machine to activate the Rinse menu.
12
Rinse all lines of the machine through the Rinse option.
13
Close the machine door.
14
Press the "Go back" key to start operation. Adjust the machine for taste and quantity desired.
15
Choose every product at least twice to check the adjustment. See chapter 4 how to change flavours.
16
3.8

Customization of bean grind and product settings

This machine has been pre-adjusted for a general espresso grind and with general settings to provide the
best in-cup quality. However, since the type of bean and instant mixture greatly affect the in-cup quality,
the grind size, dosage and many other settings may need adjustments. See chapter 4 for a short
introduction. Full support can be given by your dealer.
3.9

Instructions for the operator

After the machine has been installed and made ready for operation, the service technician has to instruct
the operator, using this manual, regarding responsible maintenance of the machine according to the local
guidelines. Safety and hygiene are central to this.
47
EN