AKG C 900 Mode D'emploi page 15

Use a cable with a female XLR connector and TS jack plug:
1. On the XLR connector, use a wire bridge to connect pin 1 to
pin 3 and the cable shield.
2. Connect the inside wire of the cable to pin 2 on the XLR
connector and the tip contact of the jack plug.
Unbalanced cables may pick up interference from stray mag-
netic fields near power or lighting cables, electric motors, etc.
like an antenna. This may introduce hum or similar noise when
you use a cable that is longer than 16 feet (5 m).
The optional TM 40 transmitter module allows you to convert
your microphone into a wireless microphone that you can use
with any WMS 40 Series receiver from AKG.
1
1. Open the fixing screw (1).
2. Pull the XLR connector module (2) out of the microphone
body.
3. To avoid losing the fixing screw (1), screw it into the thread-
ed hole (3) in the XLR connector module.
2
2
1
2 Interfacing
Note:
2.5 Optional
TM 40 Transmitter
Module
Start by removing
the XLR connec-
tor module:
Fig. 4: Removing
the XLR connector
module.
Refer to fig. 4.
Install the trans-
mitter module:
Refer to fig. 5.
Fig. 5: Installing the
transmitter module.
15