Milwaukee M12 FUEL 1/4 Manuel De L'utilisateur page 4

ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Use only sockets and other accessories specifi-
cally designed for use on impact wrenches and
drivers. Other sockets and accessories might
shatter or break causing injury.
Attaching and Removing Accessories
Square drive shank
(Cat. No. 2452-20, 2454-20)
These impact wrenchs are intended only for use with
sockets designed for impact wrenches that have a
1/4" (Cat. No. 2452-20) or 3/8" (Cat. No. 2454-20)
square drive. Other sockets could shatter or break,
causing injury.
1. To attach a socket or other accessory, align the
accessory with the drive shank and push it firmly
over the retaining ring.
2. To remove the accessory, pull the accessory off
the drive shank.
Hex drive chuck
(Cat. No. 2453-20)
This driver is intended for use with drill and driver
bits with a 1/4" hex shank and ball detent recess.
1. To attach an accessory, press the shank into the
hex drive chuck.
2. To remove the accessory, pull out the ring and
remove the accessory. Release the ring.
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Always remove battery pack before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Fuel Gauge
To determine the amount of charge left in the bat-
tery, pull the trigger. The Fuel Gauge will light up for
2-3 seconds.
To signal the end of charge, 1 light on the fuel gauge
will flash for 2-3 seconds.
Using the Drive Control
The drive control button is used to
adjust the torque, rotation speed
(RPM), and impact speed (IPM)
for the application (see Specifica-
tions chart for RPM and IPM).
To select the drive control mode:
1. Pull and release the trigger to
turn on the tool. The current
mode indicator is lit.
2. Press the drive control but-
ton to cycle through the
2 modes. When the desired
mode indiator is lit, begin work.
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha-
nism, the control switch can only be adjusted when
the ON/OFF switch is not pressed. Always allow the
motor to come to a complete stop before using the
control switch.
Push for
Forward
PUSH TO CENTER TO LOCK
1. For forward (clockwise) rotation, push the control
switch in the direction shown. Check the direction
of rotation before use.
2. For reverse (counterclockwise) rotation, push the
control switch in the direction shown. Check the
direction of rotation before use.
3. To lock the trigger, push the control switch to the
center position. The trigger will not work when the
control switch is in the locked position.
Always remove the battery pack before performing
maintenance or changing accessories. Always
lock the trigger or remove the battery pack before
storing the tool and any time the tool is not in use.
4
Drive Control
n
Butto
Mode
Indicator
Push for
Reverse