Operational Safety - Beko RDNE700E40XP Manuel D'utilisateur

Masquer les pouces Voir aussi pour RDNE700E40XP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Important safety and environment instructions
refrigerant available in your product is
specified in the Type Label.
The installation place of the product
shall not be exposed to direct sunlight
and it shall not be in the vicinity of a
heat source such as stoves, radiators,
etc.
If you cannot prevent installation of the product
in the vicinity of a heat source, you shall use a
suitable insulation plate and the minimum distance
to the heat source shall be as specified below.
- At least 30 cm away from heat sources such
as stoves, heating units and heaters, etc.,
- And at least 5 cm away from electric ovens.
Your product has the protection class
of I. Plug the product in a grounded
A
socket that conforms with
the Voltage, Current and
Frequency values specified
in the type label. The socket outlet
shall be equipped with a fuse with a
rating of 10 A – 16 A. Our company
shall not be responsible for the
damages that shall be incurred as
a result of operating the product
without ensuring ground and
electrical connections made as per
local or national regulations.
The product's power cable must
be unplugged during installation.
Otherwise, risk of electric shock and
injury may occur!
Do not plug the product to loose, broken, dirty,
greasy sockets or sockets that has come out
their seats or sockets with a risk of water
contact.
Place the power cord and hoses (if available) of
the product so that they shall not cause a risk
of tripping over.
Penetration of humidity to live parts or to the
power cord may cause short circuit. Thus, do
not use the product in humid environments or
in areas where water may splash (e.g. garage,
laundry room, etc.) If the refrigerator is wet
by water, unplug it and contact an authorized
service.
Refrigerator / User Guide
Do not connect your refrigerator to power
saving devices. These systems are harmful for
the product.

1.6 Operational safety

Do not use chemical solvents on the product.
These materials contain an explosion risk.
In case of a failure of the product, unplug it
and do not operate until it is repaired by the
authorized service. There is a risk of electric
shock!
Do not place a source of flame (e.g. candles,
cigarettes, etc.) on the product or in the vicinity
of it.
Do not get on the product. Risk of falling and
injury!
Do not cause damage to the pipes of the
cooling system using sharp and piercing tools.
The refrigerant that sprays out in case of
puncturing the gas pipes, pipe extensions or
upper surface coatings may cause irritation of
skin and injuries of the eyes.
Do not place and operate electric appliances
inside the refrigerators/deep freezer unless it is
advised by the manufacturer.
Do not jam any parts of your hands or your
body to the moving parts inside the product.
Be careful to prevent jamming of your fingers
between the refrigerator and its door. Be
careful while opening or closing the door if
there are children around.
Do not put ice cream, ice cubes or frozen food
to your mouth as soon as you take them out of
the freezer. Risk of frostbite!
Do not touch the inner walls, metal
parts of the freezer or food kept
inside the refrigerator with wet
hands. Risk of frostbite!
Do not place soda cans or cans
and bottles that contain fluids
that may be frozen to the freezer
compartment. Cans or bottles may
explode. Risk of injury and material
damage!
Do not use or place materials
sensitive against temperature
such as flammable sprays,
5 / 32 EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Rdne700e40xbrRdne700e40dzxpRdne700e41xb

Table des Matières