Sharp FU-S63E Manuel D'utilisation page 17

4 Presoak the mist filter set in
the solution prior to cleaning.
When using lemon juice,
it is recommended to
presoak longer than citric
acid.
MIST Filter Set
Do not take the MIST Filter out of the
MIST Filter Frame. If the MIST Filter is
taken out of the Frame by mistake, put it
back in the frame, as shown in the
diagram below.
MIST Filter
MIST Filter Frame
Rinse the MIST Filter set with
5
water.
• Change the water and repeat this
procedure 2-3 times.
• Use clean water each time.
• Inadequate rinsing may cause citric acid
odour or changes in the shape/colour of
the main unit.
Replacement Filter
See Page E-18
6
Wash inside the tray with water
to remove impurities.
• Do not remove the
float (Styrofoam).
• Clean difficult-to-
reach parts with a
cotton-tipped swab
or tooth brush.
7 Put the MIST Tray Cap back on
to close it.
Make sure that the cap is closed by
pushing the whole circumference of the
cap. Failure in closing the cap completely
may result water spills.
MIST Tray
8 Attach the MIST
Filter set to the
MIST Tray.
MIST Filter Set
MIST Tray
9
Put back the MIST Filter Set and
MIST Tray in the main unit.
10 Plug in the product and press the
MIST Unit Reset Button on the
main unit.
MIST Unit
Reset Button
When Float comes off, please insert the tabs
of the Float into the holes of Mist Tray as shown
in the diagram below.
Tabs
E-15
MIST Tray Cap
Float
Hole in MIST Tray