Sharp FU-S63E Manuel D'utilisation page 15

CLEAN-SIGN LIGHT
The colour changes according to
the air condition.
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the room air condition detected by the Dust and
Odour Sensors when the plug is inserted into the wall outlet.
• It is possible to have a green CLEAN-SIGN with impurities in the air at the time that the air purifier
was just introduced to the room environment. After a while, however, the base impurity rate will be
adjusted to detect room air condition correctly.
• Use the Lights ON/OFF Button on the remote control to turn off the Indicator lights.
DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will
check the conditions of the air. If operation is set to ON during this time, the CLEAN-SIGN
LIGHT will alternately flash in green, orange and red.
MIST Operation Indicator Light
Operating this product with water in its MIST Tray will prompt the
MIST Operation Indicator Light (green) to turn on, and vaporized
mist will come out automatically. To stop the vaporized mist from
being released, discard water from the tank and MIST Tray.
• The MIST Operation Indicator Light will blink for 5 minutes when the tank
water is gone, and eventually it will turn off.
• The MIST Operation Indicator Light may not correctly display if the main
unit is not sitting up straight.
When the sensors detect polluted air, air flow is increased to release
more vaporized mist and raise its air-purifying function; a healthy
environment with the appropriate humidity will be achieved.
• The amount of released vaporized mist also changes, depending on
humidity and temperature-related conditions.
Slightly Impure (Orange)
Clean (Green)
E-13
Very Impure (Red)
The light changes according
to the Tank condition.
Water is in
the Tank.
(Green)
No water is
in the Tank.
(blinking 5min.) (OFF)